Precautions for the use of fully automatic scissor fork aerial working platform 
The fully automatic fork cutting aerial work platform is a professional equipment that is convenient for the operation and lifting of goods in vertical airspace. Users need to go through a certain running in period after purchase. In order to facilitate everyone's use, I'll give you a brief explanation today. 
1. When the fully automatic scissor overhead working platform is used at one time, because the lubricating oil does not give full play to the lubricating effect in the manufacturing and design process of the machinery, this process is the time when the lifting platform consumes a lot, because each part of the lifting platform will be affected by various factors such as friction surface factors and uneven force during the assembly process. During the initial operation of the lifting platform, due to the poor sliding of each part, Part of the metal chips are worn, and the falling metal chips continue to participate in the mechanical wear. Therefore, the chips should be cleaned immediately after the operation of the equipment. 
2. The clearance between the components of the new lifting platform is small, and due to the elements of the initial assembly, the large clearance uniformity cannot be ensured. In this case, if the lubrication degree is good, the wear can be further reduced. If the lubrication condition is not good, it is easy to cause damage to small surface areas between parts and mechanical accidents. 
3. The newly assembled lifting platform is prone to loose parts. During the first few times of use of the lifting platform, it is vulnerable to the influence of vibration, environment, temperature and other factors, and there will be a large gap between the parts that are not tightly connected. Therefore, check the connection degree between various departments of the lifting platform at regular intervals to ensure the fastening of bolts. 
4. The running in between the operation engineer and the lifting platform also needs to go through a certain stage, so the engineer should carefully understand the precautions in the manual before using the equipment. 
Analysis on the inclination of automatic shear fork aerial working platform 
The fully automatic scissor fork high-altitude operation platform is a professional lifting equipment for vertical operation of people and goods. Sometimes the lifting platform will tilt due to high-altitude operation. The reason analysis and treatment methods of lifting platform tilt are compiled. 
Since the one-way throttle valve of the lifting platform for aerial work needs to be installed on the branch road of the lifting system, in order to evenly distribute the force to the hydraulic systems on both sides, it is necessary to use the one-way throttle valve to control two drivers of one oil circuit at the same time. In addition, a locking pin device is installed on the hydraulic lifting mechanism on the left. When the lift acts, the left and right hydraulic cylinders of the lift are under the same hydraulic pressure and due to different loads, The lifting speed of the hydraulic cylinders on both sides is also inconsistent to some extent. At this time, the lifting platform is easy to tilt and the electrode will sometimes be broken. 
From the cause analysis, it can be seen that using a one-way throttle valve to control two actuators with different loads in an oil circuit at the same time is the key to the inclination of the lifting platform. If four tubular one-way throttle valves are installed respectively before the oil inlet circuit and oil outlet circuit enter the hydraulic cylinder, the lifting speed of the two actuators can be adjusted respectively by removing the one-way throttle valve of the branch circuit, and the lifting speed of the lifting platform can achieve the effect of same frequency resonance, So that the lifting platform can rise and fall smoothly in the working state.